How To Light A Pilot Light On A Goodman Furnace. After a few seconds, the pilot will light up, igniting the furnace’s burners. 94 reference of pilot light goodman furnace.
Once you are sure the pilot light is on, release your pressure on the reset button. I've never seen a furnace like this. After a few seconds, the pilot will light up, igniting the furnace’s burners.
Table of Contents
Locate The Gas Control Knob Inside The Burner Compartment.
It’s possible you have an old goodman furnace with wh. Once the gas has had time to dissipate, turn the knob to pilot. then, hold down the reset button and bring the flame of a long lighter close to the pilot light opening. 73 reference of checking pilot light on goodman furnace in.
For many years now goodman furnaces have been equipped with a pilot ignitor. If you can't find the pilot light on your gas furnace, there's a good chance the furnace doesn't have one. After waiting five or 10 minutes for the gas to clear out, turn the gas valve to “pilot.”.
The Pilot Or Electric Ignition Might Be The Cause Of Your Furnace Problems.if The Pilot Light Fails To Stay Lit, This May Be A Result Of Issues Such As A Clogged Pilot Orifice, A Loose Or Faulty Thermocouple, A Defective Safety Cutoff Valve, Or The Pilot’s Flame May Have Been Set Too Low.the Thermocouple Tells The Furnace Controller That The Pilot Light Is Working.this Should Light The.
At the open end of this tube (inside the burner area) is where you will light the pilot. Turn off the knob and then wait for a few minutes to let the gas from the gas valves dissipate. Goodman furnace won’t turn on/won’t ignite.
To Reset The Pilot Light On A Furnace, You Can Look For Instructions In The User Manual.
Do you plan on doing the work yourself? The ignition button will usually will have a small red button next to it. A friend replaced the ignitor so we were able to get the pilot light and furnace relight.
94 Reference Of Pilot Light Goodman Furnace.
However, in the other two systems, the pilot is off when the furnace is off, meaning the furnace must first ignite the pilot light, which, in turn, light the burners. Using a flashlight if necessary, note the small pilot gas tube leading from the main gas valve and extending into the burner area; It has the settings on, off and pilot.